Introduction

The picture below is of a Retro-themed case that I made for the Raspberry Pi 3B+ and 3.5” TFT Touch Screen.

image-center

Final Product.

CAD Design

The design was developed using Fusion 360, of which you can see a series of pictures down below.

Raspberry Pi Retro Case Raspberry Pi Retro Case Raspberry Pi Retro Case
Raspberry Pi Retro Case CAD

Here is a closer look at the part that holds the Raspberry Pi which slides into the outside case, this part was hard to make since it had to fit correctly into the Raspberry Pi with the 3.5” Touch Screen while allowing connections to be made to the pi.

Raspberry Pi Inside Holder Raspberry Pi Inside Holder Raspberry Pi Inside Holder
Raspberry Pi Retro Case inside holder

On one part of the face of the case four custom buttons were designed, these hold a normal push button which simply slides into the holder.

Custom Button holders for push buttons Custom Button holders for push buttons Custom Button holders for push buttons
Closer look at custom button

Renders

Below you can see some renders of the whole case.

image-center

image-center

Real Model

3D Printed and Painted working model 3D Printed and Painted working model 3D Printed and Painted working model 3D Printed and Painted working model 3D Printed and Painted working model 3D Printed and Painted working model
3D Printed and Painted working model

image-center

Looking sharp.

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Tags:

Categories:

Updated:

Leave a Comment

Your email address will not be published. Required fields are marked *

Loading...